Sink Stopper Won T Seal

Peek above the sink to make sure the stopper is fully closed and that the pop up rod is pushed all the way down 3.

Sink stopper won t seal.

But sink stoppers fail. Remove stopper from drain. If water still does not hold in the sink the next check will be the actual stopper seal. If your sink pop up won t pop up or seat properly fixing it is quite easy usually just a matter of adjusting a few parts.

Gasket to push outward. Re tighten the thumb screw by turning clockwise. The gasket located under the stopper may also need to be adjusted. The ball rod is inserted into the side of the drain and attached with a nut.

Fix a sink stopper. Find replacement parts on amazon. The photo on the right fig. Remove clip from ball rod.

If a sink won t hold water look up behind the sink with a flashlight if needed to identify the following parts. The ball rod holds the stopper in the drain. When you push or pull on the lift rod it activates a lever the extends through the drain tailpiece. When they do they are often unsightly and an irritation.

To reach the stopper the ball rod needs to be removed first. It s easy to fix a bathroom sink drain plug that s leaking. 5 shows the gasket pushed out of position. A sink stopper with a push pull rod control at the faucet is a great modern convenience.

The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism. The clicker may have been over tightened causing the. It moves the stopper in the opposite direction to the lift rod. Unthread the sink stopper s tailpipe from the underside of the drain.

Now that the bottom of the tailpipe if free from the p trap loosen the nut that connects it to the threaded bottom of the sink drain. The photo on the left fig. This is a repair you can do yourself. Most sink stopper tailpipes are made of pvc and will be connected to the drain with a pvc compression nut that you can loosen by hand.

Click here for maintenance and service parts. A sink stopper mechanism isn t difficult to understand. To remove unthread the rod nut pull the ball rod out and remove the stopper from the drain. Water may leak or refuse to drain around a sink pop up for a number of reasons.

The lever hooks onto the stopper through a hole or hook on the bottom of a long plastic flange that s attached to the stopper. A pivot rod that connects to the back of the drain pipe a perforated strap a clevis and a screw that locks the strap onto the stopper rod.